Cisco Systems OL-7396-01 Manual De Usuario
7-65
ATM Switch Router Software Configuration Guide
OL-7396-01
Chapter 7
Configuring Virtual Connections
Configuring Point-to-Multipoint Soft PVC Connections
Configuring Point-to-Multipoint Soft PVCs
To configure a point-to-multipoint soft PVC connection, perform the following steps, beginning in
privileged EXEC mode:
privileged EXEC mode:
Command
Purpose
Step 1
Switch# show atm addresses
Determines the destination ATM address.
Step 2
Switch# configure terminal
Switch(config)#
At the privileged EXEC prompt, enters
configuration mode from the terminal.
configuration mode from the terminal.
Step 3
Switch(config)# interface atm card/subcard/port
Switch(config-if)#
Selects the interface to be configured.
Step 4
Switch(config-if)# atm soft-vc source-vpi
source-vci p2mp
Switch(atmsoft-p2mp)#
Changes to point-to-multipoint configuration
mode and specifies the source-VPI and
source-VCI.
mode and specifies the source-VPI and
source-VCI.
Step 5
Switch(atmsoft-p2mp)# party leaf-reference
ref-number
Switch(atmsoft-p2mp-party)#
Configures the point-to-multipoint leaf reference
number for each party and changes to
point-to-multipoint-party configuration mode.
number for each party and changes to
point-to-multipoint-party configuration mode.
Step 6
Switch(atmsoft-p2mp-party)# dest-address
atm-address dest-vpi dest-vci
atm-address dest-vpi dest-vci
Configures the destination ATM address and
destination VPI and destination VCI for each
party.
destination VPI and destination VCI for each
party.