Cisco Systems OL-7396-01 Manual De Usuario

The following example shows the point-to-multipoint soft PVC configuration of the Source switch, on 
interface ATM 0/0/1 (VPI = 50, VCI = 100):

Source# show atm vc interface atm 0/0/1 50 100

Interface: ATM0/0/1, Type: oc3suni 

VPI = 50  VCI = 100

Status: NOT CONNECTED

Time-since-last-status-change: 04:45:52

Connection-type: SoftVC 

Cast-type: point-to-multipoint-root

Hold-priority: none

 Soft vc location: Source

 Remote ATM address: default

 Remote VPI: 0  

 Remote VCI: 0

 Soft vc call state: Inactive

Packet-discard-option: disabled

Usage-Parameter-Control (UPC): pass

Wrr weight: 2

Number of OAM-configured connections: 0

OAM-configuration: disabled

OAM-states:  Not-applicable

Threshold Group: 5, Cells queued: 0

Rx cells: 0, Tx cells: 0

Tx Clp0:0,  Tx Clp1: 0

Rx Clp0:0,  Rx Clp1: 0

Rx Upc Violations:0, Rx cell drops:0

Rx Clp0 q full drops:0, Rx Clp1 qthresh drops:0

Rx connection-traffic-table-index: 1

Rx service-category: UBR (Unspecified Bit Rate)

Rx pcr-clp01: 7113539

Rx scr-clp01: none

Rx mcr-clp01: none

Rx      cdvt: 1024 (from default for interface)

Rx       mbs: none

Tx connection-traffic-table-index: 1

Tx service-category: UBR (Unspecified Bit Rate)

Tx pcr-clp01: 7113539

Tx scr-clp01: none

Tx mcr-clp01: none

Tx      cdvt: none

Tx       mbs: none

To configure the traffic parameters for a point-to-multipoint Soft PVC connection, perform the following 
steps, beginning in ATM Soft PVC point-to-multipoint configuration mode:

Switch(atmsoft-p2mp)# packet-discard {on | off 

| use-cttr}

Configures the (early) packet discard option on a 
point-to-multipoint soft PVC connection.