Cisco Systems OL-7396-01 Manual De Usuario

The word “Inactive” appears under the State field for party leaf-reference 20 disable in the previous 
section but, the second party leaf-reference 30, that was not disabled, has the word “Active” under the 
State field.

To configure the first and maximum retry intervals for each party of a point-to-multipoint Soft PVC 
connection, perform the following steps, beginning in ATM Soft PVC party configuration mode:

The following example configures the first and maximum retry intervals for each party of a 
point-to-multipoint soft PVC connection configured on an ATM interface:

Switch# config terminal

Enter configuration commands, one per line.  End with CNTL/Z.

Switch(config)# interface atm 0/0/1

Switch(config-if)# atm soft-vc 50 100 p2mp 

Switch(atmsoft-p2mp)# party leaf-reference 2

Switch(atmsoft-p2mp-party)# retry-interval first 200 maximum 300

This section describes how to delete a point-to-multipoint soft PVC configured on an interface. 

To remove the whole point-to-multipoint soft PVC connection, perform the following steps, beginning 
in global configuration mode:

The following example shows how to remove the whole point-to-multipoint soft PVC connection 
configured on ATM interface 0/0/1, VPI = 50, VCI = 100:

Source# config terminal

Enter configuration commands, one per line.  End with CNTL/Z.

Source(config)# interface atm 0/0/1

Source(config-if)# no atm soft-vc 50 100

Switch(atmsoft-p2mp-party)# retry-interval 

first {100-3600000} maximum 
{100-4294967295}

Configures the first and maximum retry 
intervals in milliseconds on a 
point-to-multipoint soft PVC connection.

Switch(config)# interface atm 

card/subcard/port

Switch(config-if)# 

Selects the interface to be configured.

Switch(config-if)# no atm soft-vc vpi vci 

Deletes all of the point-to-multipoint 
soft PVCs.