Cisco Systems OL-7396-01 Manual De Usuario
15-19
ATM Switch Router Software Configuration Guide
OL-7396-01
Chapter 15
Configuring ATM Accounting, RMON, and SNMP
Configuring ATM RMON
Displaying the Generated RMON Events
To display the generated RMON events, use the following EXEC command:
Example
The following example shows the RMON events generated using the show rmon events EXEC
command:
command:
Switch# show rmon events
Event 1 is active, owned by nms_3
Description is test
Event firing causes trap to community test, last fired 00:00:00
Configuring an RMON Alarm
You can configure RMON alarm generation if any of the configured parameters are met.
Note
Refer to the Configuration Fundamentals Configuration Guide for general SNMP RMON configuration
information.
information.
To configure RMON alarms, use the following command in global configuration mode:
Example
The following example shows how to configure RMON alarm number 1 to generate an alarm under the
following conditions:
following conditions:
•
If the MIB atmHostHCCells exceed 500
•
If each sample, in absolute mode, shows:
–
Rising threshold exceeding 10,000
–
Falling threshold falling below 1000
•
The RMON alarm number 1 sends the alarm to the owner “nms 3”
Switch(config)# rmon alarm 1 atmHostInHCCells 500 absolute rising-threshold 10000
falling-threshold 1000 owner “nms 3”
Displaying the Generated RMON Alarms
To display the RMON alarm event, use the following EXEC command:
Command
Purpose
show rmon events
Displays generated RMON events.
Command
Purpose
rmon alarm number variable interval {delta |
absolute} rising-threshold value [event-number]
falling-threshold value [event-number]
[owner string]
absolute} rising-threshold value [event-number]
falling-threshold value [event-number]
[owner string]
Configures the ATM RMON alarm.