Cisco Systems OL-7396-01 Manual De Usuario

In the following example, ATM interface 0/0/3 is configured with service class 1 and a WRR weight 
of 3:

Switch(config)# interface atm 0/0/3

Switch(config-if)# atm service-class 1 wrr-weight 3

To display the TVC configuration, perform the following task in EXEC mode:

The following example shows the service category of the TVC:

Switch# show atm vc interface atm 0/0/3 1 35

Interface: ATM0/0/3, Type: oc3suni 

VPI = 1  VCI = 35

Status: UP

Time-since-last-status-change: 1d00h

Connection-type: TVC(I) 

Cast-type: multipoint-to-point-input

Packet-discard-option: enabled

Usage-Parameter-Control (UPC): pass

Wrr weight: 2

Number of OAM-configured connections: 0

OAM-configuration: disabled

OAM-states:  Not-applicable

Cross-connect-interface: ATM0/1/3.10, Type: oc3suni 

Cross-connect-VPI = 10 

Cross-connect-VCI = 34

Cross-connect-UPC: pass

Cross-connect OAM-configuration: disabled

Cross-connect OAM-state:  Not-applicable

Threshold Group: 7, Cells queued: 0

Rx cells: 0, Tx cells: 0

Tx Clp0:0,  Tx Clp1: 0

Rx Clp0:0,  Rx Clp1: 0

Rx Upc Violations:0, Rx cell drops:0

Rx pkts:0, Rx pkt drops:0

Switch(config)# interface atm 
card/subcard/port[.vpt#]

Switch(config-if)# 

Specifies an ATM interface and enters interface 
configuration mode.

Switch(config-if)# 

 {

 | 

 | 

 | 

} 

 weight

or

Switch(config-if)# 

 {

 | 

| 

| 

} 

 weight

Enters the service class and relative weight for a 
physical interface.

or

Enters the service class and relative weight for a 
hierarchical interface.

show atm vc interface atm 
card/subcard/port [vpi vci]

Displays the ATM layer connection 
information about the virtual connection.