Cisco Systems OL-7396-01 Manual De Usuario
18-10
ATM Switch Router Software Configuration Guide
OL-7396-01
Chapter 18
Configuring Interfaces
Configuring OC-12c SM and MM Interfaces (Catalyst 8540 MSR)
Manual OC-12c Interface Configuration (Catalyst 8540 MSR)
To manually change any of the default configuration values, perform the following steps, beginning in
global configuration mode:
global configuration mode:
Examples
The following example shows how to change the default ATM interface type to private using the atm
uni type private command:
uni type private command:
Switch# configure terminal
Switch(config)# interface atm 0/0/0
Switch(config-if)# atm uni type private
The following example shows how to change the clock source using the clock source network-derived
command:
command:
Switch# configure terminal
Switch(config)# interface atm 0/0/0
Switch(config-if)# clock source network-derived
See
to confirm your interface configuration.
Command
Purpose
Step 1
Switch(config)# interface atm card/subcard/port
1
Switch(config-if)#
1.
The subcard for the full-width 622-Mbps interface module is always zero.
Specifies the ATM interface and enters interface
configuration mode.
configuration mode.
Step 2
Switch(config-if)# atm uni [side {network | user}]
[type {private | public}] [version {3.0 | 3.1 | 4.0}]
[type {private | public}] [version {3.0 | 3.1 | 4.0}]
Modifies the ATM interface side, type, or
version.
version.
Step 3
Switch(config-if)# atm maxvpi-bits max-vpi-bits
Modifies the maximum VPI bits configuration.
Step 4
Switch(config-if)# atm maxvci-bits max-vci-bits
Modifies the maximum VCI bits configuration.
Step 5
Switch(config-if)# sonet {stm-4c | sts-12c}
or
Switch(config-if)# framing {stm-4c | sts-12c}
Modifies the framing mode.
Step 6
Switch(config-if)# clock source {free-running |
loop-timed | network-derived}
loop-timed | network-derived}
Modifies the clock source.
Step 7
Switch(config-if)# sonet overhead {c2 bytes |
j0 {bytes | msg line} | j1 {16byte {exp-msg line |
msg line} | 64byte {exp-msg line | msg line}} |
s1s0 bits}
j0 {bytes | msg line} | j1 {16byte {exp-msg line |
msg line} | 64byte {exp-msg line | msg line}} |
s1s0 bits}
Modifies the path trace message.
Step 8
Switch(config-if)# sonet threshold {sd-ber |
sf-ber | b1-tca | b2-tca | b3-tca} ber
sf-ber | b1-tca | b2-tca | b3-tca} ber
Modifies the bit error rate threshold value from
3 (10e-3) to 9 (10e-9).
3 (10e-3) to 9 (10e-9).
Step 9
Switch(config-if)# sonet report {slos | slof | lais |
lrdi | pais | prdi | plop | sd-ber | sf-ber | b1-tca |
b2-tca | b3-tca}
lrdi | pais | prdi | plop | sd-ber | sf-ber | b1-tca |
b2-tca | b3-tca}
Enables reporting of selected alarms.