Cisco Systems OL-7396-01 Manual De Usuario

To verify the hard PVC configured with structured services, use the following privileged EXEC 
commands:

The following example shows the details of the hard PVC, shown in 

, using the show ces 

circuit command:

CESwitch# show ces circuit

Interface  Circuit  Circuit-Type     X-interface   X-vpi   X-vci Status

 CBR3/0/0 

1

HardPVC           ATM0/1/3      0       100 UP

The output from this command verifies the source (CBR 3/0/0) and destination (ATM 0/1/3) port IDs of 
the hard PVC and indicates that the circuit is up.

The following example shows the interface details for port CBR 3/0/0 (shown in 

), using the 

show ces circuit interface cbr command:

CESwitch# show ces circuit interface cbr 3/0/0 1

Circuit: Name CBR-PVC-A, Circuit-state ADMIN_UP / oper-state UP 

Interface CBR3/0/0, Circuit_id 1, Port-Type T1, Port-State UP

Port Clocking network-derived, aal1 Clocking Method CESIWF_AAL1_CLOCK_SYNC

Channel in use on this port: 1-3, 7

Channels used by this circuit: 1-3, 7

Cell-Rate: 4107, Bit-Rate 1544000

cas OFF, cell_header 0x100 (vci = 16)

Configured CDV 2000 usecs, Measured CDV 326 usecs

De-jitter: UnderFlow 1, OverFlow 0

ErrTolerance 8, idleCircuitdetect OFF, onHookIdleCode 0x0

state: VcAlarm, maxQueueDepth      823, startDequeueDepth      435

Partial Fill:       47, Structured Data Transfer 1

HardPVC

Src: CBR3/0/0 vpi 0, vci 16

Dst: ATM0/1/3 vpi 0, vci 100

The output from this command verifies the following configuration information:

The circuit named CBR-PVC-A is in an UP state.

The interface CBR 3/0/0 has a circuit id of 1 (because structured CES services always begin at 1 for 
each port in a CES module).

The channels being used by this circuit are 1-3 and 7.

The source port for the hard PVC is CBR 3/0/0. The destination port is ATM 0/1/3.

Shows the configuration information for the 
hard PVC.

show ces circuit interface cbr card/subcard/port 
circuit-id

Shows the detailed interface configuration 
information for the hard PVC.