Cisco Systems OL-7396-01 Manual De Usuario
19-48
ATM Switch Router Software Configuration Guide
OL-7396-01
Chapter 19
Configuring Circuit Emulation Services
Configuring T1/E1 CES SVCs
Examples
The following example shows how to display the basic information about the switched VC shown in
, using the show ces circuit command:
Switch# show ces circuit
Interface Circuit Circuit-Type X-interface X-vpi X-vci Status
CBR0/0/0 0 Active SVC ATM-P0/0/3 0 1040 UP
CBR0/0/1 0 Passive SoftVC ATM-P0/0/3 0 16 UP
The output from this command verifies the source (CBR 0/0/0) and destination (CBR 0/0/1) port IDs of
the switched VC and indicates that the circuit is up.
the switched VC and indicates that the circuit is up.
The following example shows how to display detailed information about the switched VC shown in
, using the show ces circuit interface command:
Switch# show ces circuit interface cbr 0/0/0 0
Circuit: Name CBR-SVC-A, Circuit-state ADMIN_UP / oper-state UP Interface CBR0/0/0,
Circuit_id 0, Port-Type T1, Port-State UP
Port Clocking network-derived, aal1 Clocking Method CESIWF_AAL1_CLOCK_SYNC
Channel in use on this port: 1-24
Channels used by this circuit: 1-24
Cell-Rate: 4107, Bit-Rate 1544000
cas OFF, cell_header 0x100 (vci = 16)
Configured CDV 2000 usecs, Measured CDV 331 usecs
De-jitter: UnderFlow 0, OverFlow 0
ErrTolerance 8, idleCircuitdetect OFF, onHookIdleCode 0x0
state: VcAlarm, maxQueueDepth 823, startDequeueDepth 435
Partial Fill: 47, Structured Data Transfer 0
Active SVC
Src: atm addr 47.0091.8100.0000.0004.ddec.d301.4000.0c80.0030.10 vpi 0, vci 16
Dst: atm addr 47.0091.8100.0000.0004.ddec.d301.4000.0c80.0034.10
The output from this command verifies the following configuration information:
•
The circuit named CBR-SVC-A is in an UP state.
•
The interface CBR 0/0/0 has a circuit id of 0 (because the entire bandwidth of the port is dedicated
to that circuit).
to that circuit).
•
The source port for the switched VC is CBR 0/0/0. The Dst (destination) ATM address is
47.0091.8100.0000.0004.ddec.d301.4000.0c80.0034.10.
47.0091.8100.0000.0004.ddec.d301.4000.0c80.0034.10.
Configuring T1/E1 Structured CES SVCs
shows an example of a switched VC configured for structured CES.
Note
Typically you configure a switched VC between CES modules anywhere in your network. For simplicity,
this example and the accompanying procedure describe how to create a switched VC between modules
in the same ATM switch router chassis.
this example and the accompanying procedure describe how to create a switched VC between modules
in the same ATM switch router chassis.
Command
Purpose
show ces circuit
Shows configuration information for the
switched VC.
switched VC.
show ces circuit interface cbr card/subcard/port
circuit-id
circuit-id
Shows detailed interface configuration
information for the switched VC.
information for the switched VC.