Cisco Systems OL-7396-01 Manual De Usuario
19-55
ATM Switch Router Software Configuration Guide
OL-7396-01
Chapter 19
Configuring Circuit Emulation Services
Deleting a Previously Established Circuit
Cell-Rate: 4107, Bit-Rate 1544000
cas OFF, cell_header 0x100 (vci = 16)
cdv 2000 usecs, Measured cdv 350 usecs
ErrTolerance 8, idleCircuitdetect OFF, onHookIdleCode 0x0
state: VcAlarm, maxQueueDepth 879, startDequeueDepth 491
Partial Fill: 47, Structured Data Transfer 0
HardPVC
src: CBR3/0/0 vpi 0, vci 16
Dst: ATM0/1/3 vpi 0, vci 100
The output from this command verifies the following configuration information:
•
The circuit named CBR-PVC-A is UP.
•
The clock source is network-derived.
•
The AAL1 clocking method is synchronous.
Deleting a Previously Established Circuit
This section describes how to delete a previously established circuit.
To delete a previously established circuit, follow these steps, beginning in privileged EXEC mode:
Example
The following example shows how to delete a previously established circuit:
CESwitch# show ces circuit
Interface
Circuit
Circuit-Type X-interface X-vpi X-vci Status
CBR3/0/0
0
HardPVC
ATM0/0
0
100
UP
CBR3/0/3
0
HardPVC
ATM0/0
0
101
UP
CESwitch# configure terminal
CESwitch(config)# interface cbr 3/0/0
CESwitch(config-if)# no ces circuit 0
CESwitch(config-if)# exit
CESwitch(config)# interface cbr 3/0/3
Command
Purpose
Step 1
Switch# show ces circuit
Shows the configuration information for the
circuit.
circuit.
Step 2
Switch# configure terminal
Switch(config)#
Enters global configuration mode from the
terminal.
terminal.
Step 3
Switch(config)# interface cbr card/subcard/port
Switch(config-if)#
Selects the physical interface where the circuit is
to be deleted.
to be deleted.
Step 4
Switch(config-if)# no ces circuit circuit-id
Deletes the CES circuit.
Step 5
Switch(config-if)# exit
Switch(config)#
Exits interface configuration mode and returns to
global configuration mode.
global configuration mode.
Step 6
Switch(config)# interface cbr card/subcard/port
Switch(config-if)#
Selects the other physical interface where the
circuit is to be deleted.
circuit is to be deleted.
Step 7
Switch(config-if)# no ces circuit circuit-id
Deletes the other end of CES circuit.