Cisco Systems OL-7396-01 Manual De Usuario
20-14
ATM Switch Router Software Configuration Guide
OL-7396-01
Chapter 20
Configuring Frame Relay to ATM Interworking Port Adapter Interfaces
Configuring LMI
Rx Bytes : 2432424
Rx Frames Discarded : 3
Rx Bytes Discarded : 1032
Total Rx Frames with DE : 0
Rx Frames with DE Tagged Locally : 0
Total Rx Frames with FECN : 0
Rx Frames with FECN Tagged Locally : 0
Total Rx Frames with BECN : 0
Rx Frames with BECN Tagged Locally : 0
Rx connection-traffic-table-index: 102
Rx service-category: VBR-NRT (Non-Realtime Variable Bit Rate)
Rx pir: 64000
Rx cir: 64000
Rx Bc : 32768
Rx Be : 32768
Rx Frame Size : 64
Tx connection-traffic-table-index: 102
Tx service-category: VBR-NRT (Non-Realtime Variable Bit Rate)
Tx pir: 64000
Tx cir: 64000
Tx Bc : 32768
Tx Be : 32768
Tx Frame Size : 64
Switch#
The Rx Frame Size and Tx Frame Size fields display the new VC frame size configuration.
Step 6
Use the show running-config command to confirm GAT is configured on the interface VC.
Switch# show running-config interface serial 1/0/1:1
Building configuration...
Current configuration : 268 bytes
!
interface Serial1/0/1:1
no ip address
encapsulation frame-relay IETF
no ip route-cache
no ip mroute-cache
no arp frame-relay
frame-relay intf-type nni
frame-relay soft-vc 128 dest-address 47.0091.8100.0000.0090.2156.d801.4000.0c80.1010.00
dlci 43 rx-cttr 102 tx-cttr 102 gat
end
Switch#
The keyword “gat” appears in the interface VC configuration confirming GAT is enabled.
Configuring LMI
Three industry-accepted standards are supported for addressing the Local Management Interface (LMI),
including the Cisco specification. By default, the Cisco ILMI option is active on your Frame Relay
interface.
including the Cisco specification. By default, the Cisco ILMI option is active on your Frame Relay
interface.