Cisco Systems OL-7396-01 Manual De Usuario

To display the reachability information, use the show atm route command.

NewYork.BldB.T2# show atm route

 

Codes: P - installing Protocol (S - Static, P - PNNI, R - Routing control),

       T - Type (I - Internal prefix, E - Exterior prefix, SE -

                 Summary Exterior prefix, SI - Summary Internal prefix,

                 ZE - Suppress Summary Exterior, ZI - Suppress Summary Internal)

 

P  T Node/Port        St Lev Prefix

~ ~~ ~~~~~~~~~~~~~~~~ ~~ ~~~ ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

P  I 9   0            UP 0   47.0091.4455.6677.1144.1011.1233/104

P SI 1   0            UP 0   47.0091.4455.6677.1144.1011.1244/104

R  I 1   ATM2/0/0     UP 0   47.0091.4455.6677.1144.1011.1244.0060.3e5b.bc01/152

R  I 1   ATM2/0/0     UP 0   47.0091.4455.6677.1144.1011.1244.0060.3e5b.bc02/152

R  I 1   ATM2/0/0     UP 0   47.0091.4455.6677.1144.1011.1244.4000.0c/128

P  I 11  0            UP 0   47.0091.4455.6677.1144.1011.1255/104

P  E 11  0            UP 0   47.0091.4455.6677.22/64 

S  E 1   ATM0/0/1     DN 0   47.0091.8200.0001.1/60 

The initial configuration for switch NewYork BldB.T3 follows:

hostname NewYork.BldB.T3

atm address 47.0091.4455.6677.1144.1011.1255.0060.3e5b.c401.00

atm router pnni

 node 1 level 72 lowest

  redistribute atm-static

interface ATM0/0/2

 no ip address

atm route 47.0091.4455.6677.22... ATM0/0/2

To display the reachability information, use the show atm route command. To display the interface 
type, use the show atm interface command:

NewYork.BldB.T3# show atm interface atm 0/0/2

 

Interface:      ATM0/0/2        Port-type:      oc3suni

IF Status:      UP              Admin Status:   up

Auto-config:    enabled         AutoCfgState:   completed

IF-Side:        Network         IF-type:        IISP

Uni-type:       not applicable  Uni-version:    V4.0

<information deleted>

In the example, the interface type of interface atm 0/0/2 on NewYork.BldB.T3 is determined using 
Integrated Local Management Interface (ILMI) autoconfiguration. Because the other side of the link on 
SanFran.BldA.T4 is configured as IISP, the interface type is determined to be IISP. When using ILMI 
autoconfiguration on one side of the link and manually configuring the other side as IISP, be careful to 
specify the configured side as either the user or network side, depending on whether it has the larger 
value of atmfMySystemIdentifier.