Cisco Systems OL-7396-01 Manual De Usuario

After you have configured the IP address(es) for the Ethernet interface, test for connectivity between the 
switch and a host. The host can reside anywhere in your network. To test for Ethernet connectivity, use 
the following user EXEC command:

For example, to test Ethernet connectivity from the switch to a workstation with an IP address of 
172.20.40.201, enter the command ping ip 172.20.40.201. If the switch receives a response, the 
following message displays:

Switch# ping ip 172.20.40.201

Type escape sequence to abort.

Sending 5, 100-byte ICMP Echos to 172.20.40.201, timeout is 2 seconds:

!!!!!

Success rate is 100 percent (5/5), round-trip min/avg/max = 1/202/1000 ms

Use the ping atm interface command to confirm that the ATM connections are configured correctly:

Switch# ping atm interface atm 3/0/0 0 5 seg-loopback

Type escape sequence to abort.

Sending Seg-Loopback 5, 53-byte OAM Echoes to a neighbour,timeout is 5 seconds:

!!!!!

Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/4 ms

Switch#

ping ip ip-address

Tests the configuration using the ping 
command. The ping command sends an echo 
request to the host specified in the command.