Cisco Systems OL-8241-02 Manual De Usuario

An OSPF interface is an IP interface that you configure to send and receive OSPF 
traffic. To configure the CSS IP interface as an OSPF interface, use the ospf 
command. 

You must enter the ospf command before the ospf enable command can take 
effect. 

To configure the CSS IP interface as an OSPF interface:

Access the circuit configuration mode for the preconfigured circuit on which 
you want to create the IP interface. For example, if circuit VLAN6 already 
exists, enter:

(config)# circuit VLAN6

(config-circuit[VLAN6])#

Refer to 

 for 

information on how to configure the CSS interfaces and circuits, and 
bridge interfaces to VLANs.

Create the IP interface to the circuit. To create an IP address of 3.1.2.2, enter:

(config-circuit[VLAN6])# ip address 3.1.2.2/24

Create ip interface <3.1.2.2>, [y/n]:y

Configure this circuit as an OSPF circuit. Enter:

(config-circuit-ip[VLAN6-3.1.2.2])#