Cisco Systems OL-8241-02 Manual De Usuario
7-3
Cisco Content Services Switch Routing and Bridging Configuration Guide
OL-8241-02
Chapter 7 Configuring the Cisco Discovery Protocol
Enabling CDP
The following running-configuration example shows the results of entering the
commands in
commands in
.
!*************************** GLOBAL ***************************
cdp run
cdp holdTime 255
cdp timer 120
Enabling CDP
By default, CDP is disabled for the CSS. Use the cdp run global configuration
command to enable CDP transmissions from the CSS to other neighboring Cisco
CDP-compatible devices on the network.
command to enable CDP transmissions from the CSS to other neighboring Cisco
CDP-compatible devices on the network.
For example:
(config)# cdp run
To disable CDP transmissions on the CSS, enter:
(config)# no cdp run
Setting the CDP Hold Time
The CDP hold time is the amount of time a receiving device retains the CDP
information sent by the CSS (time-to-live information) before discarding this
information. If a neighboring device does not receive a CDP message before the
hold time expires, the neighboring device drops the CSS as a neighbor. By
default, the hold time is 180 seconds. To specify the hold time, use the cdp
holdTime global configuration command. Valid entries are 10 to 255 seconds.
information sent by the CSS (time-to-live information) before discarding this
information. If a neighboring device does not receive a CDP message before the
hold time expires, the neighboring device drops the CSS as a neighbor. By
default, the hold time is 180 seconds. To specify the hold time, use the cdp
holdTime global configuration command. Valid entries are 10 to 255 seconds.
To specify a CDP hold time of 255 seconds for the receiving device, enter:
(config)# cdp holdTime 255
To reset the CDP hold time back to the default value of 180 seconds, enter:
(config)# no cdp holdTime