Cisco Systems 1000 Series Manual De Usuario
2-9
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
OL-16506-17
Chapter 2
Getting Help
Table 2-5
Finding Command Options
Command
Comment
Router> enable
Password: <password>
Router#
Enter the enable command and password to access
privileged EXEC commands. You are in privileged
EXEC mode when the prompt changes to a “
privileged EXEC commands. You are in privileged
EXEC mode when the prompt changes to a “
#
” from
the “
>
”; for example,
Router> to Router#
.
Router# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#
Enter the configure terminal privileged EXEC
command to enter global configuration mode. You
are in global configuration mode when the prompt
changes to
command to enter global configuration mode. You
are in global configuration mode when the prompt
changes to
Router(config)#
.
Router(config)# interface serial ?
<0-6>
Serial interface number
Router(config)# interface serial 4 ?
/
Router(config)# interface serial 4/ ?
<0-3>
Serial interface number
Router(config)# interface serial 4/0 ?
<cr>
Router(config)# interface serial 4/0
Router(config-if)#
Enter interface configuration mode by specifying
the serial interface that you want to configure using
the interface serial global configuration command.
the serial interface that you want to configure using
the interface serial global configuration command.
Enter ? to display what you must enter next on the
command line. In this example, you must enter the
serial interface slot number and port number,
separated by a forward slash.
command line. In this example, you must enter the
serial interface slot number and port number,
separated by a forward slash.
When the <cr> symbol is displayed, you can press
Enter to complete the command.
Enter to complete the command.
You are in interface configuration mode when the
prompt changes to
prompt changes to
Router(config-if)#.
Router(config-if)# ?
Interface configuration commands:
.
.
.
ip
Interface Internet Protocol config
commands
keepalive
Enable keepalive
lan-name
LAN Name command
llc2
LLC2 Interface Subcommands
load-interval
Specify interval for load calculation
for an
interface
locaddr-priority
Assign a priority group
logging
Configure logging for interface
loopback
Configure internal loopback on an
interface
mac-address
Manually set interface MAC address
mls
mls router sub/interface commands
mpoa
MPOA interface configuration commands
mtu
Set the interface Maximum Transmission
Unit (MTU)
netbios
Use a defined NETBIOS access list or
enable
name-caching
no
Negate a command or set its defaults
nrzi-encoding
Enable use of NRZI encoding
ntp
Configure NTP
.
.
.
Router(config-if)#
Enter ? to display a list of all the interface
configuration commands available for the serial
interface. This example shows only some of the
available interface configuration commands.
configuration commands available for the serial
interface. This example shows only some of the
available interface configuration commands.