Cisco Systems 1000 Series Manual De Usuario
16-18
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
OL-16506-17
Chapter 16 Configuring MPLS Layer 2 VPNs
Configuring Frame Relay DLCI-to-ATM AAL5SNAP Bridged Interworking
Step 12
exit
Exits pseudowire class configuration mode.
Step 13
interface loopback
loopback-interface-number
Example:
Router(config)# interface loopback 0
Specifies the loopback logical interface.
Step 14
ip address
ip-address mask
Example:
Router(config-if)# ip address 44.1.1.2
255.255.255.255
Specifies the IP address for the Loopback interface.
Step 15
exit
Exits interface configuration mode.
Step 16
interface GigabitEthernet
slot/subslot/port
Example:
Router(config)# interface GigabitEthernet 0/0/1
Specifies the Gigabit Ethernet interface for the
connection of the PE routers.
connection of the PE routers.
Step 17
ip address
ip-address mask
Example:
Router(config-if)# ip address 10.10.1.2
255.255.255.0
Specifies the IP address for the Gigabit Ethernet
interface.
interface.
Step 18
negotiation auto
Example:
Router(config-if)# negotiation auto
Enables the auto negotiation protocol to configure
the speed, duplex, and automatic flow control of the
Gigabit Ethernet interface.
the speed, duplex, and automatic flow control of the
Gigabit Ethernet interface.
Step 19
mpls ip
Example:
Router(config-if)# mpls ip
Enables MPLS forwarding of the IPv4 packets
towards the MPLS core.
towards the MPLS core.
Step 20
exit
Exits interface configuration mode.
Step 21
interface atm
slot/subslot/port
Example:
Router(config)# interface atm 0/1/2
Configures an ATM interface and enters interface
configuration mode.
configuration mode.
Step 22
no ip address
Example:
Router(config-if)# no ip address
Removes the previously configured IP address.
Step 23
atm clock internal
Example:
Router(config-if)# atm clock internal
Enables the ATM interface to generate the transmit
clock internally.
clock internally.
Command or Action
Purpose