Cisco Systems 1000 Series Manual De Usuario
16-24
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
OL-16506-17
Chapter 16 Configuring MPLS Layer 2 VPNs
Configuring Frame Relay DLCI-to-ATM AAL5SNAP Bridged Interworking
Step 23
interface serial
slot/subslot/port:timeslot
Example:
Router(config)# interface Serial0/3/0:0
Specifies a serial interface created on a channelized
T1 controller.
T1 controller.
Step 24
no ip address
Example:
Router(config-if)# no ip address
Removes the previously configured IP address.
Step 25
encapsulation frame-relay
Example:
Router(config-if)# encapsulation frame-relay
Configures the Cisco Frame Relay encapsulation on
serial interface.
serial interface.
Step 26
frame-relay intf-type dce
Example:
Router(config-if)# frame-relay intf-type dce
Configures a Frame Relay switch type. The router
functions as a switch connected to a router.
functions as a switch connected to a router.
Step 27
frame-relay interface-dlci
dlci switched
Example:
Router(config-if)# frame-relay interface-dlci 101
switched
Assigns a data-link connection identifier (DLCI) to
a specified Frame Relay subinterface on the router.
a specified Frame Relay subinterface on the router.
Step 28
exit
Exits interface configuration mode.
Step 29
interface GigabitEthernet
slot/subslot/port
Example:
Router(config)# interface GigabitEthernet 0/0/1
Specifies the Gigabit Ethernet interface for the
connection of the PE routers.
connection of the PE routers.
Step 30
ip address
ip-address mask
Example:
Router(config-if)# ip address 10.10.1.2
255.255.255.0
Specifies the IP address for the Gigabit Ethernet
interface.
interface.
Step 31
negotiation auto
Example:
Router(config-if)# negotiation auto
Enables the auto negotiation protocol to configure
the speed, duplex, and automatic flow control of the
Gigabit Ethernet interface.
the speed, duplex, and automatic flow control of the
Gigabit Ethernet interface.
Step 32
mpls ip
Example:
Router(config-if)# mpls ip
Enables MPLS forwarding of the IPv4 packets
towards the MPLS core.
towards the MPLS core.
Step 33
exit
Exits interface configuration mode.
Command or Action
Purpose