Cisco Systems 1000 Series Manual De Usuario
16-35
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
OL-16506-17
Chapter 16 Configuring MPLS Layer 2 VPNs
Configuring Gigabit EtherChannel for Virtual Private Wire Service
Note
Ethernet-to-EtherChannel over MPLS (Bridge) Interworking mode is also supported under VLAN.
Any-to-EtherChannel over MPLS (Routed) Interworking
You can configure Any-to-EtherChannel over MPLS (Routed) interworking on the Cisco ASR 1000
Series Routers.
Series Routers.
Any-to-EtherChannel over MPLS (Routed) interworking supports the following modes:
•
ATM-to-EtherChannel
•
Ethernet-to-EtherChannel
•
PPP-to-EtherChannel
Configure L2VPN interworking on the upstream interfaces of PE routers. For more information about
configuring L2VPN interworking on the PE routers, see
configuring L2VPN interworking on the PE routers, see
For information about how to configure ATM on the downstream interfaces of a PE router, see the
. Meanwhile,
perform the steps described in the
, on the downstream interfaces of the other PE router.
For the Ethernet-to-EtherChannel mode, see the
.
For the PPP-to-EtherChannel mode, perform the steps described in the
, on the downstream interfaces of the other PE router.
Meanwhile, perform the following steps on the downstream interfaces of the PE routers:
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
(Optional) ipv6 unicast-routing
4.
mpls ip default-route
5.
mpls ldp graceful-restart
6.
xconnect logging pseudowire status
7.
controller t1 slot | subslot | port
8.
clock source internal
9.
linecode b8zs
10.
cablelength long db-loss-value
11.
channel-group channel-group-number timeslots range
12.
exit
13.
pseudowire-class pw-class-name
14.
encapsulation mpls
15.
interworking ethernet
16.
exit