Cisco Systems 1000 Series Manual De Usuario

--------- --------------- ---------- ------ ------------------------ ----------

pw145     104.0.0.1       145        p2p    foo145                   UP        

Router# show l2vpn atom vc detail

pseudowire145 is up, VC status is up PW type: Ethernet

  Create time: 00:00:18, last status change time: 00:00:13

    Last label FSM state change time: 00:00:13

  Destination address: 104.0.0.1 VC ID: 145

    Output interface: Fa0/0/1, imposed label stack {16 33}

    Preferred path: not configured  

    Default path: active

    Next hop: 10.1.1.2

  Member of xconnect service foo145

    Associated member Se0/1/0:0 is up, status is up

    Interworking type is Ethernet

    Service id: 0x2e

  Signaling protocol: LDP, peer 104.0.0.1:0 up

    Targeted Hello: 102.0.0.1(LDP Id) -> 104.0.0.1, LDP is UP

    Graceful restart: configured and enabled

    Non stop routing: not configured and not enabled

    PWid FEC (128), VC ID: 145

    Status TLV support (local/remote)         : enabled/supported

      LDP route watch                         : enabled

      Label/status state machine              : established, LruRru

      Local dataplane status received         : No fault

      BFD dataplane status received           : Not sent

      BFD peer monitor status received        : No fault

      Status received from access circuit     : No fault

      Status sent to access circuit           : No fault

      Status received from pseudowire i/f     : No fault

      Status sent to network peer             : No fault

      Status received from network peer       : No fault

      Adjacency status of remote peer         : No fault

  Sequencing: receive disabled, send disabled

  Bindings

    Parameter    Local                          Remote

    ------------ ------------------------------ ------------------------------

    Label        33                             33

    Group ID     0                              0

    Interface    Connect to CE1                 Connect to CE2                

    MTU          1500                           1500

    Control word on (configured: autosense)     on

    PW type      Ethernet                       Ethernet

    VCCV CV type 0x02                           0x02

                   LSPV [2]                       LSPV [2]                    

    VCCV CC type 0x07                           0x07

                   CW [1], RA [2], TTL [3]       CW [1], RA [2], TTL [3]

    Status TLV   enabled                        supported

  SSO Descriptor: 104.0.0.1/145, local label: 33

  Dataplane:

    SSM segment/switch IDs: 4345/4344 (used), PWID: 48

  Rx Counters

    2 input transit packets, 108 bytes

    0 drops, 0 seq err 

  Tx Counters

    3 output transit packets, 183 bytes

    0 drops

The following example shows how to verify the Qinq configuration on PE:

Router# show mpls l2transport vc