Cisco Systems 1000 Series Manual De Usuario
18-66
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
OL-16506-17
Chapter 18 LSM-MLDP-based MVPN Support
MVPN MLDP over GRE
Step 8
mdt default mpls MLDP
root-node
Example:
Router(config-vrf-af)# mdt default mpls
MLDP 1.1.1.1
Configures MLDP MDT for a VRF.
root-node
—The root node can be IP address of a
loopback or physical interface on any router (source PE,
receiver PE, or core router) in the provider network. The
root node address should be accessible to all the routers
in the network. The router from where signalling occurs
functions as the root node.
receiver PE, or core router) in the provider network. The
root node address should be accessible to all the routers
in the network. The router from where signalling occurs
functions as the root node.
The default MDT must be configured on each PE router
to enable the PE routers to receive multicast traffic for this
particular MVRF.
to enable the PE routers to receive multicast traffic for this
particular MVRF.
Note
Creates the LSPVIF tunnel with the mdt default
mpls MLDP root-node command.
mpls MLDP root-node command.
Step 9
mdt default mpls MLDP
root-node
Example:
Router(config-vrf-af)# mdt default mpls
MLDP 1.1.1.2
Configures Root Node Redundancy.
root-node
—The root node can be IP address of a
loopback or physical interface on any router (source PE,
receiver PE, or core router) in the provider network. The
root node address should be accessible to all the routers
in the network. The router from where signaling occurs
functions as the root node.
receiver PE, or core router) in the provider network. The
root node address should be accessible to all the routers
in the network. The router from where signaling occurs
functions as the root node.
The default MDT must be configured on each PE router
to enable the PE routers to receive multicast traffic for this
particular MVRF.
to enable the PE routers to receive multicast traffic for this
particular MVRF.
Step 10
mdt data mpls MLDP
number_of_data_MDTs
Example:
Router(config-vrf-af)# mdt data mpls
MLDP 20
Configures the MLDP data MDP.
Command
Purpose