Cisco Systems 1000 Series Manual De Usuario
5-8
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
OL-16506-17
Chapter 5 Software Upgrade Processes Supported by Cisco ASR 1000 Series Routers
ISSU Upgrade for Redundant Platforms
DETAILED STEPS
Command or Action
Purpose
Step 1
ip tftp
source-interface gigabitethernet slot/port
Example:
Router(config)# ip tftp source-interface
gigabitethernet
0
Specifies the Gigabit Ethernet TFTP
source-interface to be configured:
source-interface to be configured:
slot/port—Specifies the location of the TFTP
source-interface.
source-interface.
Note
To copy a file using TFTP through the
Management Ethernet interface, the ip tftp
source-interface GigabitEthernet 0
command must be entered before entering
the copy tftp command.
Management Ethernet interface, the ip tftp
source-interface GigabitEthernet 0
command must be entered before entering
the copy tftp command.
Step 2
copy tftp:
URL-to-target-location
copy
source-file-system
:
filename
standby-destination-filesystem
Example:
Router# copy tftp bootflash:
Copy the consolidated package onto the active RP.
Step 3
copy
source-file-system
:
filename
standby-destination-filesystem
Example:
Router# copy
bootflash:asr1000rp1-adventerprisek9.02.01.01.122-33.
XNA1.bin stby-bootflash:
Copy the consolidated package onto the standby RP.
Step 4
dir
URL-to-target-location
dir
URL-to-target-stby-location
Example:
Router# dir bootflash:
Router# dir stby-bootflash:
(Optional) Display the contents of the target
directories to confirm the successful copy of the file
package.
directories to confirm the successful copy of the file
package.
Step 5
issu loadversion rp
upgrade-rp-number
standby-file-system
:
filename
Example:
Router# issu loadversion rp 1 file
stby-bootflash:asr1000rp1-adventerprisek9.02.01.01.12
2-33.XNA1.bin
Load the target consolidated package onto the
standby RP.
standby RP.
After you receive the message indicating that the
terminal state has been reached, go on to
terminal state has been reached, go on to