Cisco Systems 2500 SERIES Manual De Usuario

If you are using a wireless IP camera, or a wired IP 
camera on a network connection that does not provide 
PoE, connect the optional 12 V power adapter.

First, connect the bare wires at the end of the power 
adapter to the terminal block that is provided with the IP 
camera:

With the screws on the terminal block facing down, 
put the positive wire into the slot at the right rear of 
the terminal block and put the negative wire into the 
slot on the left. (On the Cisco power adapter, the 
positive wire has a white stripe and the negative wire 
has no stripe.)

Use a small flat-head screwdriver to tighten the 
screws on the bottom of the terminal block so that the 
power adapter wires are attached securely.

The power adapter may include an attached 
terminal block that does not fit the IP camera. If 
so, remove that terminal block and replace it with 
the one that is provided with the IP camera.

Next, plug the terminal block into the power input port on 
back of the IP camera. The terminal block fits into the 
input port in one way. Make sure that the tabs on the 
terminal block face the bottom of the IP camera.

Finally, plug the power adapter into an electrical outlet. 
The IP camera powers up.

Check the LEDs on the IP camera.

The Ready LED blinks while the IP camera starts up. 
After 15 to 20 seconds, startup completes and the 
Ready LED should remain on. 

The Network LED should be on.

Wireless model only: If you connected the IP camera to 
a router, switch, or Ethernet port on a PC as described in 

, configure wireless settings, then power down the 

IP camera, disconnect the network cable, and power up 
the IP camera.

Connect to the IP camera as described in the 

configure wireless settings as described in 

 At a 

minimum, you must configure the service set identifier 
(SSID) in the Basic Setup window.

After configuring, disconnect the power cable and the 
network cable, then reconnect the power cable. After the 
IP camera powers up, make sure that the Ready LED and 
Network LED are on.

Mount the IP camera in the desired location.

Connect the mounting device to the threaded mounting 
hole on the bottom or top of the IP camera, depending on 
your installation requirement.

You may first need to remove the rubber protector from the 
mounting hole. Place this protector in the unused 
mounting hole.

Optional. Use the lockdown cable slot to secure the IP 
camera.

You can secure the IP camera to a fixed object by using 
Kensington-compatible lockdown equipment