Cisco Systems 9000 Manual De Usuario

2-37

Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide

Chapter 2 Unpacking and Installing the Chassis

Removing Components Before Installing the Chassis

Figure 2-32

Cisco ASR 9912 Router Components and Slot Numbering with Version 3 AC Power
System

Follow these steps to remove RP cards, FCs, and LCs from the Cisco ASR 9922 Router and
Cisco ASR 9912 Router chassis.

Step 1

Use

Figure 2-27

Figure 2-31

to identify each card and then write down the card type and slot number

on a piece of paper. You will need this information when you reinstall the cards in the chassis to be sure
you reinstall each card in its original slot.

Step 2

To remove a FC card (

Figure 2-33

Figure 2-34

), starting at the lowest numbered slot:

Remove the air filter covering the front of the middle cage.

Use a screwdriver to loosen the captive screws at the ends of the FC front panel.

Push in both ejector lever release buttons.

Note

Once any ejector lever release button is pushed in, the FC must by physically removed and
reinserted (OIR) to restart the FC.

Pivot the ejector levers to unseat the FC from the backplane connector.

363712

M11

M10

PS0

Power modules

PS1

PS2

Fan trays

(rear instertion)

Line cards

LC0

LC1

LC2

LC3

LC4

LC5

LC6

LC7

LC8

LC9

Slot 0

Slot 1

Slot 2

Slot 3

Slot 4

Slot 5

Slot 6

Slot 7

Slot 8

Slot 9

FT0
FT1

RP0

FC0

FC6

RP1

FC1

FC2

FC3

FC4

FC5

Power shelves/trays