Cisco Systems 9000 Manual De Usuario

Install the captive screw in each ejector lever into the screw hole in the power tray frame (

or 

).

Use the 6-inch long number 2 Phillips screwdriver to tighten the two ejector screws to a torque of 10 +/-1 
in-lb to secure the ejectors and to secure the tray to its mating connector.

Install and tighten two screws through the power tray mounting ears on each side into the screw holes in 
the chassis mounting ears to secure the tray to the chassis.

This section describes the procedures for removing and installing an RSP card, RP card, FC, or LC. 

See the 

for information about removing and installing SIP and SPA cards.

For a information about the router components and slot numbering for the Cisco ASR 9010 Router, 
Cisco ASR 9006 Router, and Cisco ASR 9904 Router, see 

.

For a information about the router components and slot numbering for the Cisco ASR 9922 Router 
and Cisco ASR 9912 Router, see 

.

Handle all cards by the metal card carrier edges only; avoid touching the board or any connector pins. 
After removing a card, carefully place it in an antistatic bag or similar environment to protect it from 
ESD and dust in the optic ports (fiber-optic line cards).

Be careful to avoid damaging the EMI gasket that runs along the full height of the card front panel edges. 
Damage to the EMI gasket can affect the ability of your system to meet EMI requirements.

To avoid damaging card mechanical components, never carry an RSP card, RP card, FC, or LC by the 
captive installation screws or ejector levers. Doing so can damage these components and cause card 
insertion problems.

The BPID board monitors OIR by counting the number of card insertions for each slot and saving that 
information in non-volatile memory. OIR monitoring is done for all line cards, the RSP, the RP, and the 
fan trays. See 

 for more information.