Cisco Systems 9000 Manual De Usuario
1-28
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
Chapter 1 Preparing for Installation
Site Requirement Guidelines
Cisco ASR 9006 Clearance Requirements
To install a Cisco ASR 9006 Router in a 4-post enclosed cabinet:
•
The front and rear doors of the cabinet must be removed or be perforated with a minimum open area
of 70 percent. In addition, the right side panel must be removed or perforated with a minimum of 65
percent open area (70 percent for ETSI 800-mm racks).
of 70 percent. In addition, the right side panel must be removed or perforated with a minimum of 65
percent open area (70 percent for ETSI 800-mm racks).
•
There must be a minimum unobstructed space of 6 inches (15.24 cm) between the router’s right side
air inlet and the adjacent wall or cabinet side panel, and a minimum unobstructed space of 6 inches
(15.24 cm) between adjacent cabinets. In addition, there should be no exhaust from any source
blowing into the right side panel of the cabinet.
air inlet and the adjacent wall or cabinet side panel, and a minimum unobstructed space of 6 inches
(15.24 cm) between adjacent cabinets. In addition, there should be no exhaust from any source
blowing into the right side panel of the cabinet.
–
Rear chassis clearance: Minimum of 2.50 inches (6.40 cm) of clearance.
–
Sides chassis clearance: Minimum of 6 inches (15.24 cm) of clearance on the right side of the
chassis (as viewed from the front). There is no clearance requirement for the left side of the
chassis.
chassis (as viewed from the front). There is no clearance requirement for the left side of the
chassis.
9006 Router in a 4-post enclosed rack.