Cisco Systems 9000 Manual De Usuario
1-61
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
Chapter 1 Preparing for Installation
RSP and RP Port Connection Guidelines
When lit, these LEDs indicate for UTI:
•
Green (NORMAL)—UTI is operating in normal mode.
•
Amber (FAST)—UTI is operating in fast mode.
Figure 1-66
SYNC Port Connector
SFP/SFP+ Port
The RSP-440 and RSP-440 Lite support two 10-GE Small Form-Factor Pluggable Plus (SFP+)
virtualization cluster ports. The RSP-880 supports four 10-GE SFP+ ports that are used for external
server connectivity capability.
virtualization cluster ports. The RSP-880 supports four 10-GE SFP+ ports that are used for external
server connectivity capability.
GPS Interface
The RSP-440, RSP-440 Lite, and RSP-880 have a Time of Day (ToD) port, 10-MHz connector, and
1-PPS connector that allow you to configure input or output clocking with a GPS device.
1-PPS connector that allow you to configure input or output clocking with a GPS device.
Inter Chassis Synchronization Port
The nV Sync 0 and nV Sync 1 ports on the RSP-440, RSP-440 Lite, and RSP-880 are the RJ-45
inter-chassis synchronization clock interfaces for synchronizing frequency and time.
inter-chassis synchronization clock interfaces for synchronizing frequency and time.
Table 1-9
BITS/J.211 Connector Pinout
Pin
Signal
Note
1
DTI_P/BITS_RX_P
Bi-direction for DTI, T1/E1/64K Input
2
DTI_P/BITS_RX_N
Bi-direction for DTI, T1/E1/64K Input
3
—
—
4
BITS_TX_P*
T1/E1/6.321M Output
5
BITS_TX_N*
T1/E1/6.321M Output
6
—
—
7
—
—
8 —
—
243166
1 2 3 4 5 6 7 8