Cisco Systems A9KMOD80TR Manual De Usuario

F I N A L D R A F T — C i s c o C o n f i d e n t i a l

3-37

Cisco ASR 9000 Series Aggregation Services Router Getting Started Guide

OL-17502-01

Chapter 3 Configuring General Router Features

Configuring the Management Ethernet Interface

Examples

In the following example, the Management Ethernet interface on the RSP in slot RSP1 is configured with
an IP address:

RP/0/RSP0/CPU0:router# configure

RP/0/RSP0/CPU0:router(config)# interface MgmtEth0/RSP1/CPU0/0

RP/0/RSP0/CPU0:router(config-if)# ipv4 address 10.1.1.1 255.255.255.0

RP/0/RSP0/CPU0:router(config-if)# no shutdown

RP/0/RSP0/CPU0:router(config-if)# commit

RP/0/RSP0/CPU0:router(config-if)# end

RP/0/RSP0/CPU0:router#

RP/0/RSP0/CPU0:router# show interfaces mgmtEth 0/RSP0/CPU0/0

MgmtEth0/RSP0/CPU0/0 is up, line protocol is up

Hardware is Management Ethernet, address is 0011.93ef.e8ea (bia 0011.93ef.e8e)

Description: Connected to Lab LAN

Internet address is 10.1.1.1/24

MTU 1514 bytes, BW 100000 Kbit

reliability 255/255, txload Unknown, rxload Unknown

Encapsulation ARPA, loopback not set,

ARP type ARPA, ARP timeout 04:00:00

Last clearing of "show interface" counters never

5 minute input rate 0 bits/sec, 0 packets/sec

5 minute output rate 0 bits/sec, 0 packets/sec

375087 packets input, 22715308 bytes, 87 total input drops

0 drops for unrecognized upper-level protocol

Received 297320 broadcast packets, 0 multicast packets

0 runts, 0 giants, 0 throttles, 0 parity

48 input errors, 43 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort

89311 packets output, 6176363 bytes, 0 total output drops

Output 53 broadcast packets, 0 multicast packets

Step 8

end

Example:

Saves configuration changes.

•

When you issue the end command, the system
prompts you to commit changes:

Uncommitted changes found, commit them before

exiting(yes/no/cancel)?

[cancel]:

–

Entering yes saves configuration changes to the
running configuration file, exits the configuration
session, and returns the router to EXEC mode.

–

Entering no exits the configuration session and
returns the router to EXEC mode without
committing the configuration changes.

–

Entering cancel leaves the router in the current
configuration session without exiting or
committing the configuration changes.

Step 9

show interfaces MgmtEth

rack/

slot

/CPU0/

port

Example:

RP/0/RSP0/CPU0:router(config)# interface MgmtEth

0/RP0/CPU0/0

Displays statistics for the management interfaces
configured on the router.

Command or Action

Purpose