Cisco Systems 880 Manual De Usuario
2-3
Cisco 860 Series and Cisco 880 Series Integrated Services Routers Hardware Installation Guide
OL-16193-01
Chapter 2 Installing the Router
Installing the Router
Installing the Router
This section describes how to install the Cisco 860 series and Cisco 880 series ISRs. These routers can
either be installed on a table top or other flat horizontal surface or be mounted on a wall.
either be installed on a table top or other flat horizontal surface or be mounted on a wall.
Warning
This equipment needs to be grounded. Use a green and yellow 12 to 14 AWG ground wire to connect
the host to earth ground during normal use. Statement 242
the host to earth ground during normal use. Statement 242
Warning
This unit is intended to be mounted on a wall. Please read the wall mounting instructions carefully
before beginning installation. Failure to use the correct hardware or to follow the correct procedures
could result in a hazardous situation to people and damage to the system. Statement 248
before beginning installation. Failure to use the correct hardware or to follow the correct procedures
could result in a hazardous situation to people and damage to the system. Statement 248
Warning
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024
Caution
Do not cover or obstruct the router vents located on both sides of the router; otherwise, overheating could
occur and cause damage to the router.
occur and cause damage to the router.
Caution
Do not place anything on top of the router that weighs more than 10 pounds (4.5 kilograms), and do not
stack routers on a desktop. Excessive weight on top of the router could damage the chassis.
stack routers on a desktop. Excessive weight on top of the router could damage the chassis.
Caution
Do not install the router or power supplies next to a heat source of any kind, including heating vents.
Installing on a Table
To install the router on a table or other flat horizontal surface, firmly place the router on a table, or other
horizontal surface. Keep at least 1 in. (2.5 cm) of clear space beside the cooling inlet and exhaust vents.
horizontal surface. Keep at least 1 in. (2.5 cm) of clear space beside the cooling inlet and exhaust vents.
Connect the chassis to a reliable earth ground. For the chassis ground connection procedures, see the
Mounting on a Wall
The Cisco 860 series and Cisco 880 series ISRs have mounting holes on the bottom of the chassis for
mounting the unit on a wall or other vertical surface.
mounting the unit on a wall or other vertical surface.
Note
The mounting holes are bidirectional. You can hang the router with the LEDs either facing you or facing
away from you.
away from you.