Cisco Systems 1710 Manual De Usuario

After the router is powered on, the following LEDs confirm that you have correctly installed your router. 

For more information about installing or configuring your Cisco 1710 Security router, see the following documents available 
on Cisco.com:

Cisco Security Device Manager Troubleshooting Guide

The Cisco Warranty card, included in the accessory kit, which lists telephone numbers, e-mail addresses, and World Wide 
Web URLs for getting information directly from Cisco Systems

For more information about SDM, visit http://www.cisco.com/go/sdm

Cisco documentation and additional literature are available on Cisco.com. Cisco also provides several ways to obtain technical 
assistance and other technical resources. These sections explain how to obtain technical information from Cisco Systems.

You can access the most current Cisco documentation at this URL:

You can access the Cisco website at this URL:

PWR

Front

On when power is being supplied to the router.

OK

Front

On when the router software is loaded and 
functional.

Blinking when the router is running a power-on 
self-test (POST). Continual blinking can indicate a 
problem with the router, although the LED will 
also blink if the router is in ROMMON mode. 
Refer to the “Troubleshooting” chapter in the 
hardware installation guide for more information.

LNK (One for each Ethernet 
port)

Back

On when the router is correctly connected to the 
Ethernet network through the 10BT and 10/100 
ETHERNET ports.

FDX (One for each Ethernet 
port)

Back

On when the associated Ethernet port is operating 
in full-duplex mode. The 10BT port does not 
perform autosensing for full-/half-duplex mode; 
the default setting is for half-duplex operation.

100 (10/100 ETHERNET port 
only)

Back

On when the 10/100 ETHERNET port is 
operating at 100 Mbps.

10BT ACT and 10/100 ACT 

Front

Blinking when there is network traffic on the 
Ethernet connections.