Cisco Systems 8540 CSR Manual De Usuario
4-3
Layer 3 Switching Software Feature and Configuration Guide
78-6235-04, Cisco IOS Release 12.0(10)W5(18)
Chapter 4 Configuring Interfaces
General Instructions for Configuring Interfaces
Figure 4-1
Interface Port Identifier Format
The interface port identifiers on the Ethernet modules remain the same regardless of whether other
modules are installed or removed. However, when you move an interface module to a different slot, the
first number in the address changes to reflect the new slot number.
modules are installed or removed. However, when you move an interface module to a different slot, the
first number in the address changes to reflect the new slot number.
You can identify module ports by physically checking the slot/subslot/interface location on the back of
the switch router. You can also use Cisco IOS show commands to display information about a specific
interface, or all the interfaces, in the switch router.
the switch router. You can also use Cisco IOS show commands to display information about a specific
interface, or all the interfaces, in the switch router.
General Instructions for Configuring Interfaces
The following general configuration instructions apply to all interfaces. Begin in global configuration
mode. To configure an interface, follow these steps:
mode. To configure an interface, follow these steps:
Step 1
Use the configure EXEC command at the privileged EXEC prompt to enter the global configuration
mode.
mode.
Router> enable
Router# configure terminal
Router (config)#
Step 2
Enter the interface command, followed by the interface type (for example, Fast Ethernet or Gigabit
Ethernet) and its interface port identifier (see the “Interface Port Identifier” section on page 4-2).
Ethernet) and its interface port identifier (see the “Interface Port Identifier” section on page 4-2).
For example, to configure the Gigabit Ethernet port on slot 1, port 1, use this command:
Router(config)# interface gigabitethernet 1/0/1
slot number / subslot number / interface number
27934
The slot in which the
interface module or port
adapter is installed.
Slots are numbered
starting at 0.
interface module or port
adapter is installed.
Slots are numbered
starting at 0.
The subslot in which the
interface module or port
adapter is installed. For a
full-width interface
module, this number is
always 0.
interface module or port
adapter is installed. For a
full-width interface
module, this number is
always 0.
The port or interface
number on the interface
module or port adapter.
Numbering always starts
at 0 and goes from left to
right.
number on the interface
module or port adapter.
Numbering always starts
at 0 and goes from left to
right.