Compatible Systems 5.4 Manual De Usuario

Interface Configuration Dialog Box

v Note:  If you need more information about bridging, see “Bridging 101” 
in the Appendices to this manual.

To access this dialog box, select Interface/Bridging from the Device View. 
This can be done for any type of interface except IP subinterfaces. 

Bridging operates on physical network addresses (such as Ethernet 
addresses), rather than logical addresses (such as IP or IPX addresses). From 
the standpoint of routing, router interfaces which are set to bridge between 
themselves appear as a single logical entity.

Thus, a “Bridge Group” is made up of all of the physical network interfaces 
in a router which have been set to bridge the same protocol. Whether an inter-
face bridges a protocol is set in the protocol configuration dialog box for each 
individual physical interface. See, for instance, the IP Routing/Bridging/Off 
radio buttons in the TCP/IP Routing: Ethernet Configuration Dialog Box.

Each Bridge Group can have routing parameters set for it. All of the interfaces 
in the group share these parameters. To access the dialog boxes which set 
these parameters, select Protocol/Bridging for the desired protocol (e.g. IP, 
IPX, etc.).