Linksys AG241 Manual De Usuario

10

Chapter 4: Connecting the ADSL2 Gateway with 4-Port 

Switch

The Gateway’s setup consists of more than simply plugging hardware together. You will have to configure your 
networked computers to accept the IP addresses that the Gateway assigns them (if applicable), and you will also 
have to configure the Gateway with setting(s) provided by your Internet Service Provider (ISP).

The installation technician from your ISP should have left the setup information for your modem with you after 
installing your broadband connection. If not, you can call your ISP to request that data. 

After you have the setup information you need for your specific type of Internet connection, you can begin 
installation and setup of the Gateway.

1. Before you begin, make sure that all of your network’s hardware is powered off, including the Gateway and 

all computers.

2. Connect one end of an Ethernet network cable to one of the Ethernet ports (labeled 1-4) on the back of the 

Gateway (see Figure 4-1), and the other end to an Ethernet port on a computer. 

3. Repeat this step to connect more computers, a switch, or other network devices to the Gateway.

 

NOTE:  A small device called a microfilter (not included) may be necessary between each 
phone and wall jack to prevent interference.  Contact your ISP if you have any questions.