3com NETBuilder SI Manual De Usuario
76
C
HAPTER
6: B
ASIC
C
ONFIGURATION
OF
P
ORTS
AND
P
ATHS
before you connect it to the SuperStack II bridge/router. See the
documentation that came with your TA for more information.
documentation that came with your TA for more information.
To configure the serial port with a DCE, follow these steps:
1 The default baud rate for the serial port is 64 Kbps. If you need to change
the baud rate, use:
SETDefault !<path> -PATH Baud = <kbps> (1.2-2048)
2 The default device type is Modem. Specify the external device type
attached to the Flex-WAN cable using:
SETDefault !<path> -PATH ExDevType = [Modem | Bri | Sw56]
3 If you have changed any of the default settings, re-enable the path to
make sure all settings on the path take effect using:
SETDefault !<path> -PATH CONTrol = Enabled
Configuring Serial
Ports with DTEs
Ports with DTEs
This section describes how to configure the serial ports when connecting
directly to IBM legacy equipment.
directly to IBM legacy equipment.
Before beginning this procedure, complete the following tasks:
■
Attach the Flex-WAN cable to the serial port and the DTE.
■
Log on to the system with Network Manager privilege.
The Flex-WAN serial port automatically detects the following settings:
■
Line type — leased
■
Clock — internal
■
Connector type — RS-232, V.35, X.21, or RS-449
To configure the serial port with a DTE, follow these steps:
1 The default baud rate for the serial port is 64 Kbps. If you need to change
the baud rate, use:
SETDefault !<path> -PATH Baud = <kbps> (1.2-2048)
2 Set the owner of the serial port using:
SETDefault !<port> -PORT OWNer = BSC | ATUN | SHDLC | SDLC
See Using Enterprise OS Software for more information about IBM legacy
protocols.
protocols.