3com WL-603 Manual De Usuario

C

HAPTER

 2: I

NSTALLING

 

THE

 R

OUTER

When positioning your Router, ensure:

■

It is out of direct sunlight and away from sources of heat.

■

Cabling is away from power lines, fluorescent lighting fixtures, and 
sources of electrical noise such as radios, transmitters and broadband 
amplifiers.

■

Water or moisture cannot enter the case of the unit.

■

Air flow around the unit and through the vents in the side of the case 
is not restricted. 3Com recommends you provide a minimum of 
25 mm (1 in.) clearance.

Use the four self-adhesive rubber feet to prevent your Router from 
moving around on your desk or when stacking with flat top units. Only 
stick the feet to the marked areas at each corner of the underside of your 
Router.

There are two slots on the underside of the Router that can be used for 
wall mounting. The Router must be mounted with the LEDs facing 
upwards.

To wall mount the unit:

1 Make two holes 98 mm (3.9 in.) apart and insert two nylon or similar 

screw anchors that are suitable for the wall construction.

2 Fix two suitable screws into the anchors, leaving their heads 3 mm (0.12 

in.) clear of the wall surface. The screws should be at least 30 mm (1.2 
in.) long. 

3 Remove any connections in the Router and locate it over the screw heads. 

When in line, gently push the Router on to the wall and move it 
downwards to secure.