3com WL-575 Manual De Usuario

6-54

C

HAPTER

 6: C

OMMAND

 L

INE

 I

NTERFACE

snmp-server targets <target-id> <ip-addr> <sec-name> 

 

  [version {3}] [udp-port {port-number}] [notification-type 

 

  {TRAP}]

 

no snmp-server targets <target-id>

• target-id - A user-defined name that identifies a receiver of SNMP 

notifications. (Maximum length: 32 characters)

• ip-addr - Specifies the IP address of the management station to receive 

notifications.

• sec-name -  The defined SNMP v3 user name that is to receive 

notifications.

• version - The SNMP version of notifications. Currently only version 3 is 

supported in this command.

• udp-port - The UDP port that is used on the receiving management 

station for notifications.

• notification-type - The type of notification that is sent. Currently only 

TRAP is supported.

None

Global Configuration

• The access point supports up to 10 SNMP v3 target IDs.
• The SNMP v3 user name that is specified in the target must first be 

configured using the snmp-server user command.

snmp-server filter
This command configures SNMP v3 notification filters. Use the no form to delete 
an SNMP v3 filter or remove a subtree from a filter.

Outdoor 11a Building to Building(config)#snmp-server targets mytraps 

192.254.2.33 chris

Outdoor 11a Building to Building(config)#