3com OfficeConnect Remote 812 Manual De Usuario
B-14
A
PPENDIX
B: CLI C
OMMAND
D
ESCRIPTION
disable lan access
When the access list is enabled, this command disables access to Hosts on the
local LAN interface. When disabled, all frames received on the LAN interface are
subject to the access list check. If the corresponding LAN subnet is not in the
access list, the frame is silently discarded.
local LAN interface. When disabled, all frames received on the LAN interface are
subject to the access list check. If the corresponding LAN subnet is not in the
access list, the frame is silently discarded.
disable link_traps
interface
<interface_name>
Prevents SNMP from sending linkup and linkdown traps for the specified interface.
You can see if the interface is currently enabled for traps by using the show
interface settings command.
You can see if the interface is currently enabled for traps by using the show
interface settings command.
disable network service
<service_name>
Disables a network service, such as TELNET or TFTP. If close_active_connection’ was
specified as TRUE in the add network_service command, then all active
connections will be closed when the server is disabled.
specified as TRUE in the add network_service command, then all active
connections will be closed when the server is disabled.
disable security_option
snmp user_access
Turns off SNMP access to the CLI. This prevents remote users from using SNMP
and possibly damage the configuration. You can use enable security_option snmp
user_access to re-enable full SNMP access.
and possibly damage the configuration. You can use enable security_option snmp
user_access to re-enable full SNMP access.
disable security_option
remote_user
administration
Disables CLI access to remote TELNET users. All CLI configuration must be done
from the console port. You can use enable security_option remote_user
administration to re-enable remote CLI access.
from the console port. You can use enable security_option remote_user
administration to re-enable remote CLI access.
disable snmp
authentication traps
Instructs SNMP to stop recording trap information for user (either local or remote)
authentication.
authentication.
disable telnet escape
Disables the TELNET escape character for all TELNET clients. When disabled,
TELNET clients who press the escape character during their session will not get a
local TELNET command line.
TELNET clients who press the escape character during their session will not get a
local TELNET command line.
disable tunnel
<tunnel_name>
Deactivates the specified tunnel.
disable user
<user_name>
Disables the specified user from being used. It also causes all active sessions
established using that particular user to terminate, and does not allow any new
sessions to occur using that user name. Disabling a user is useful when prohibiting
a user’s access temporarily.
established using that particular user to terminate, and does not allow any new
sessions to occur using that user name. Disabling a user is useful when prohibiting
a user’s access temporarily.
disable vc
<user_name>
Disables the specified virtual channel from being used. It also causes any active
session established using that particular VC to terminate, and does not allow any
new sessions to occur using that VC. Disabling a VC is useful when prohibiting a
VC’s access temporarily.
session established using that particular VC to terminate, and does not allow any
new sessions to occur using that VC. Disabling a VC is useful when prohibiting a
VC’s access temporarily.
DO
do
<command_inputfile>
output [outputfile]
Runs a script file that is stored in FLASH memory, which contains a series of CLI
commands.
commands.