3com OfficeConnect Remote 812 Manual De Usuario

B-24

PPENDIX

B: CLI C

OMMAND

ESCRIPTION

SAVE

save all

Saves all changes you have made during your session with the CLI. It is a good idea
to save your changes frequently, just as you should with any type of editor.

SET

set adsl reset

Resets the ADSL interface.

set adsl wire [pair]

Overrides the auto-direction of inner and outer pair wiring on the RJ-11 connector.

inner - inner pair.

outer - outer pair.

set bridge

aging_time <seconds>

forward_delay <seconds>

spanning_tree_priority <seconds>

Sets parameters for all bridge networks.

set bridge firewall

[firewall_mode]

Sets the mode of the Bridge Firewall function. The three modes are completely
described in Chapter 6.

discard_routed_protocols - packets for routed protocols are not bridged.

fwd_unicast_packets_only - unicast packets for routed protocols may also
be bridged. Broadcast and multicast packets are not bridged.

fwd_bc_and_unicast - broadcast, multicast and unicast packets for routed
protocols may also be bridged.

set command

history <numerical range>

idle timeout <minutes>

local_prompt <string>

prompt <string>

Sets console parameters for CLI commands.

Parameter

Description

aging_time

Interval to wait before aging out MAC addresses that were learned from
other LAN segments. The default is 300.

forward_delay

Interval bridge waits before bridging packets. This time is useful for the
bridge to listen to packets, look at the MAC addresses, and build its known
MAC address table. Default is 15 seconds.

spanning_tree_
priority

Priority number determines who will be seen as the “root” bridge in a bridge
network. The default is 32768.

Parameter

Description

history

Sets the depth of the buffer holding the command history. Use the
history command to see the current depth and a list of your last CLI
commands. The default is 10 commands. The range is 1-500.