3com OfficeConnect Remote 812 Manual De Usuario
CLI Commands
B-41
show bridge settings
Displays the settings for all bridge networks. Use set bridge to modify these values.
Base Aging Time - time to age out a known MAC address, default 300
Spanning Tree Forward Delay - delay after coming up before learning,
default is 15
default is 15
Spanning Tree Priority - this bridge’s bid to be root bridge, default is
32768
32768
Access MACs Only - This can be enabled or disabled.
Spanning Tree Mode - sets spanning tree algorithm on. Default is
DISABLED
DISABLED
Base MAC Address - address of the bridge
Number of Networks - number of networks in this bridge
Type - type of bridge: TRANSPARENT_ONLY is the default
show call_log
Displays the current call status of a specified VC.
Fields:
Call State: current call state of the call (i.e. Disconnected, Connecting,
Connected).
Connected).
Last Clearing reason: indicates why the call was cleared. Reasons for clearing
include, line down, PPP timeout, Authentication error, Network configuration
error, and termination initiated from the local and remote side.
include, line down, PPP timeout, Authentication error, Network configuration
error, and termination initiated from the local and remote side.
IP, IPX, and Bridge status: current status of each network layer.
Configured - protocol is configured for this VC and the call is being
initiated
initiated
Not configured - The protocol is disabled on this VC.
Established - Protocol was negotiated successfully and is currently active
on this VC.
on this VC.
Failure - Protocol was configured, but there was a failure in the PPP
negotiation while attempting to initiate the network layer.
negotiation while attempting to initiate the network layer.
show command
Displays the settings for Command History Depth, and the Current Prompt. You
can modify the history depth using set command history, and alter the prompt
using set command prompt. Prompts can hold a maximum of 64 characters. For
example:
can modify the history depth using set command history, and alter the prompt
using set command prompt. Prompts can hold a maximum of 64 characters. For
example:
settings
Displays information about the specified bridge network. You use add bridge
network to define bridge networks.
network to define bridge networks.
Interface - the interface this bridge is using
Network Address - index number for this bridge network
Frame Type - BRIDGE is the default
Status - ENABLED or DISABLED are options
User Name - user to supply parameters for this bridge
Spanning Tree Enabled - ENABLED or DISABLED