3com SuperStack 3 NBX Manual De Usuario
194
C
HAPTER
3: D
EVICE
C
ONFIGURATION
Rebooting a
Line Card Port
To reboot a line card port:
1 Select NBX NetSet > Device Configuration > Line Card Ports.
2 From the list, select the port that you want to reboot.
3 Click Status. The Device Status dialog box appears.
4 Click Reset Device.
5 Click OK.
CAUTION: On the 3C10117 Analog Line Card, you can reboot individual
ports without affecting the other ports. However, if you reboot a port on
the 3C10117C Analog Line Card, all four ports on the card are rebooted.
Active telephone calls on any of these ports are disrupted.
ports without affecting the other ports. However, if you reboot a port on
the 3C10117C Analog Line Card, all four ports on the card are rebooted.
Active telephone calls on any of these ports are disrupted.
Details of last 5 calls
Information about the most recent five completed calls on a
port:
port:
■
Call Direction
:
Indicates whether the call originated
from inside the NBX system (outgoing call) or from
outside (incoming call). Values: Incoming, Outgoing.
outside (incoming call). Values: Incoming, Outgoing.
■
Duration
:
Length of the call in seconds.
■
Called Party
:
The number or extension receiving the
call.
■
Calling Party
:
The number or extension originating the
call.
■
Disconnect
:
Indicates that a disconnect signal has been
received (the external party has hung up) or not
received. Values: Received, Not Received.
received. Values: Received, Not Received.
■
DTMF Digits: The digits that were dialed during the
call. This information appears only if the check box is
enabled.
call. This information appears only if the check box is
enabled.
■
Compression: Indicates the audio compression
technique used during the call. MULAW is used for
voice calls. ADPCM is used for voice mail.
Values: MULAW, ADPCM, ALAW, Linear.
technique used during the call. MULAW is used for
voice calls. ADPCM is used for voice mail.
Values: MULAW, ADPCM, ALAW, Linear.
Table 34 Device Status Dialog Box Fields (continued)
Field
Purpose