3com 10014302 Manual De Usuario

Using the ntp-service authentication-keyid command, you can set an NTP 

authentication key. Using the undo ntp-service authentication-keyid command, you 

can remove the NTP authentication key.

 

By default, there is no authentication key. 

This command enables you to set an NTP authentication key. So far, only MD5 

authentication is supported. 

Set an MD5 authentication key, given the key ID is 10 and the key value is BetterKey.

 

[3Com] ntp-service authentication-keyid 10 authentication-mode md5 BetterKey 

ntp-service broadcast-client

 

undo ntp-service broadcast-client

 

Interface view

 

None

 

Using the ntp-service broadcast-client command, you can configure the NTP 

broadcast client mode. Using the undo ntp-service broadcast-client command, you 

can disable the NTP broadcast client mode.

 

By default, NTP broadcast client service is not configured. 

With this command, you can specify the current interface on the local device to 

receive NTP broadcast messages and the local device to work in broadcast-client 

mode. The local router first detects the broadcast message packets from the server. 

Upon the receipt of the first broadcast message packet, the local router enters a 

temporary Client/Server mode to exchange the message with the remote server for 

the purpose of estimating the network delay, and then it switches to the broadcast 

3Com Router Command Reference Guide Addendum for V1.2

73