3com 10014303 Manual De Usuario

Restore the SETUP message.

undo isdn ignore llc

Configure the router to wait for CONNECT ACK message
replies from the connected exchange until switching to the
ACTIVE state.

isdn waitconnectack

Configure the router to become ACTIVE to start data exchange
before receiving CONNECT ACK messages.

undo isdn waitconnectack

The ISDN SETUP message contains the following information elements by default:

• High-layer Compatibility

• Low-Layer Compatibility

• Sending Complete

These can optionally be removed from the SETUP message.

6.3 Configuring the SPID Parameters of ISDN NI

Table 6-8 SPID Commands

Operation

Command

On the BRI interface set the processing mode of the SPID to
NIT, i.e., non-initializing terminal mode.

isdn spid nit

Remove the NIT mode on BRI interface.

undo isdn spid nit

Modify the time-interval of timer TSPID.

isdn spid timer seconds

Restore the default value of the time-interval,

undo isdn spid timer

Set the number of times to resend a message on the BRI
interface.

isdn spid resend times

Restore the default number of times to resend a message.

undo isdn spid resend

Set the SPID value of channel B1.

isdn spid1 spid

Delete the SPID value of channel B1.

undo isdn spid1

Set the SPID value of channel B2.

isdn spid2 spid

Delete the SPID value of channel B2.

undo isdn spid2

Enable SPID negotiation on the BRI interface.

isdn spid auto-trigger

Configure the service types that must be supported in SPI
negotiation on the BRI.

isdn spid service [audio | data | speech]

Delete the service types that are not supported in SPI
negotiation.

undo isdn spid service

By default, there is no NIT mode and no SPID 1 or SPID 2 value. SPID works in

AUTO mode. The time-interval for the TSPID Timer is 30 seconds. Information can

only be resent once.

3Com Router Configuration Guide Addendum for V1.20