3com 500 Manual De Usuario
Installation
1-17
Connecting the Power
CAUTION:
First, read the section;
at the
start of this guide and the
Isolate the electrical mains system supply before commencing installation.
Ensure that the On/Off switch is set to its ‘OFF’ position.
1
Plug the mains lead into the power socket of the AccessBuilder 500
(see
on
2
Plug the other end of the mains lead into an adjacent electrical mains
system outlet socket and if necessary turn on the power at the outlet
socket.
3
The AccessBuilder 500 performs a self test procedure (Figure 6.2) which
ends with the unit displaying its media access control (MAC) address
for approximately ten seconds. The display then alternates between
'NoName', with its default IP address '10.0.0.1' showing, and its port
status 'LAN 1: DOWN'. The unit's POWER and ALERT LEDs light and the
ALARM LED flashes.
Figure 1-5
Power Connection And On/Off Switch