SMC Networks 2.4GHz/5GHz Manual De Usuario
Command Line Interface
7-62
wds channel
This command selects the radio band to be used for WDS
forwarding (bridging).
forwarding (bridging).
Syntax
wds channel <a | g | none>
• a - Bridging is supported on the 802.11a 5 GHz band.
• g - Bridging is supported on the 802.11b/g 2.4 GHz band.
• none - Bridging is not supported for either band.
• g - Bridging is supported on the 802.11b/g 2.4 GHz band.
• none - Bridging is not supported for either band.
Default
802.11a
Command Mode
Global Configuration
Example
wds mac-address
This command enters Ethernet MAC Addresses in the WDS
forwarding table for each node in the wireless bridge network.
forwarding table for each node in the wireless bridge network.
Syntax
wds mac-address <port-id> <mac-address>
• port-id - The wireless port number for the bridge link. (1 for
Slave units; 1-16 for Master units)
• mac-address - The Ethernet MAC Address of the remote
bridge unit for this link. (12 hexadecimal digits in the form
“xx-xx-xx-xx-xx-xx”)
“xx-xx-xx-xx-xx-xx”)
Default
none
AP(config)#wds channel a
AP(config)#
AP(config)#