Quatech WLNG-ET Series Manual De Usuario
Initial Configuration
100-8007-141G AirborneDirect™
Ethernet Bridge User's Guide
Page 21
Quatech, Inc. Confidential
VERIFYING YOUR CONNECTIONS
When the Bridge is powered-up, the indicator LEDs at the top of the Bridge will indicate the
status of the Bridge. See Table 2 on page 11 for standard packaging, or Table 3 on page 15 for
Heavy-Duty packaging.
If the LEDs indicate a problem with a wired or wireless connection, remove the power source
from the Bridge, wait a few seconds, and re-apply power. If the LEDs still do not behave
appropriately, see the guidelines in Table 11 on page 52.
Note:
Other Access Points in the area may interfere with the Bridge’s ability to
associate with your chosen Access Point (the Bridge will try to associate with
the first available “best-quality” AP). If you encounter difficulties with connecting
to your chosen AP, either remove power from these Access Points or move to
an isolated location and perform the setup shown in Figure 1 on page 3.
associate with your chosen Access Point (the Bridge will try to associate with
the first available “best-quality” AP). If you encounter difficulties with connecting
to your chosen AP, either remove power from these Access Points or move to
an isolated location and perform the setup shown in Figure 1 on page 3.