Schneider Electric 61 Manual De Usuario

8

 

Since the Altivar ATV 61 was first launched, it has benefited from the addition of several new functions. The software version has been 
updated to version V1.6. The old versions can be replaced by this new one without any modifications.
Although this documentation relates to version V1.6, it can still be used with earlier versions, as the updates merely involve the addition of 
new values and parameters and none of the previous version parameters have been modified or removed.
The software version is indicated on the nameplate attached to the body of the drive.

• The external fault 

[EXTERNAL FAULT]

 (EtF-)

 can now be configured in positive or negative logic via 

[External fault config.]

 (LEt)

.

Note: In versions V1.1 and V1.2, analog output AO1 was assigned to the motor frequency. In the new version, this output is not 
assigned.
With the exception of this parameter, the factory settings of versions V1.1 and V1.2 remain the same in the new version. The new 
functions are inactive in the factory setting. 

Addition of states and internal values relating to the new functions described below.

•

[High torque thd.]

 

(ttH)

•

[Low torque thd.]

 

(ttL)

•

[Pulse warning thd.]

 

(FqL)

•

[Freewheel stop Thd]

 

(FFt)

• Extension of the following configurations to all drive ratings (previously limited to 45 kW (60 HP) for ATV61

ppp

M3X and to 75 kW (100 

HP) for ATV61

ppp

N4): synchronous motor 

[Sync. mot.]

 

(SYn)

, sinus filter 

[Sinus filter]

 

(OFI)

, noise reduction 

[Noise reduction]

 

(nrd)

, 

braking balance 

[Braking balance]

 (bbA)

. 

•

[AI net. channel]

 (AIC1)

• New options for assigning relays and logic outputs: torque greater than high threshold, torque lower than low threshold, motor in 

forward rotation, motor in reverse rotation, measured speed threshold attained.

• Analog output AO1 can now be used as a logic output and assigned to relay functions and logic outputs.
• New option of modifying the scaling of analog outputs using the parameters 

[Scaling AOx min]

 

(ASLx)

 and 

[Scaling AOx max]

 

(ASHx)

.

• New options for assigning analog outputs: signed motor torque and measured motor speed.
• New options for assigning alarm groups: torque greater than high threshold, torque less than low threshold, measured speed 

threshold attained.

• The summing, subtraction and multiplication reference functions can now be assigned to virtual input 

[Network AI]

 (AIU1)

.

• New parameter 

[Freewheel stop Thd]

 (FFt)

 used to adjust a threshold for switching to freewheel at the end of a stop on ramp or fast stop.

• The torque limitation 

[TORQUE LIMITATION]

 (tOL-)

 can now be configured in whole % or in 0.1% increments using 

[Torque 

increment]

 (IntP)

 and assigned to virtual input 

[Network AI]

 (AIU1)

.

• New Damper control function using the 

[DAMPERMANAGEMENT]

 

(dAM-)

 menu.

• Parameter switching 

[PARAM. SET SWITCHING]

 (MLP-)

 can now be assigned to attained frequency thresholds 

[Freq. Th. attain.]

 

(FtA) 

and 

[Freq. Th. 2 attain.]

 (F2A)

.