Schneider Electric E4800 Manual De Usuario

© 201

 Schneider Electric All Rights Reserved

This section contains the following installation topics:

•

•

•

The pre-installation checklist and site planning must be performed before 
installing the equipment at the site. 

The equipment required for each PowerLogic EM4800 meter installation 
includes:

•

high-density meter (PowerLogic EM4833, PowerLogic EM4880 or 
PowerLogic EM4805)

•

For the PowerLogic EM4833 and PowerLogic EM4880, one 12-ft (4-m) 
AMP cable with one 50-pin connector supplied with each unit

•

For the PowerLogic EM4805, two Mate-n-Lok

TM

 wiring harnesses 

supplied with each unit in 8-, 12-, or 24-connector variants

•

CD and meter configuration software, this installation manual and an 
installation record form

When you receive your order, verify that the items listed above are included 
with the shipment, and visually inspect them for damage. If any parts are 
missing or damaged, contact your Schneider Electric representative.

The installer must provide the following information, tools, and equipment 
before proceeding with the installation:

•

certified current transformers for metering (not supplied)

•

an appropriate 15-Amp maximum circuit breaker or a fused disconnect 
switch for the type of panel

•

current/voltage meter to test the phasing of panels

•

RJ45 Ethernet patch cable

•

4-wire 14 AWG (1.63 mm

2

) cable for three-phase wye connected 

circuits, or 3-wire 14 AWG (1.63 mm

2

) cable for a single-phase wye 

connected circuits

•

small flat-head screwdriver

•

#2 Phillips screwdriver

•

crimping tool

•

18 AWG butt splice connector

•

wire strippers

•

four 1-inch (25 mm) #8 mounting screws suitable for selected mounting 
surface