TP-LINK TD-W8950ND Manual De Usuario

)

ETH and ATM service can not coexist. If the ATM Interface had configured, you cannot configure 
any other WAN service over the ETH Interface until the ATM Interface is deleted. 

If your ISP provides a PPPoE connection and you need to use an ETH Interface, follow the steps 
below to add a WAN service over a selected ETH interface:   

1.  Add a new ETH interface on the screen of 

2. Click 

the 

Add button on the screen Figure 4-7 and the following configuration is similar to 

PPPoE over ATM interface (see section 

4.4.2.1 ATM-EoA-PPPoE

If your ISP provides an IPoE connection and you want to use an ETH Interface, follow the steps 
below to add a WAN service over a selected ETH interface: 

1.  Add a new ETH interface on the screen of 

2. Click 

the 

Add button on the screen Figure 4-7 and the next configuration is similar to IPoE 

over ATM interface (see section 

If you want to adopt the Bridge service and you need to use an ETH Interface, follow the steps 
below to add a WAN service over a selected ETH interface: 

1.  Add a new ETH interface on the screen of 

2. Click 

the 

Add button on the screen Figure 4-7 and the next configuration is similar to Bridge 

over ATM interface (see section 

Choose menu “Advanced Setup”Æ“MAC Clone”, you can configure the MAC address of the 
WAN Interface as shown below. 

The WAN Interface List displays the Lay2 Interfaces you have configured on the section 

 and its default MAC Address. If you have not configured corresponding WAN 

Service for the interface on the section 

4.4.2 WAN Service

“Need a corresponding WAN Service”. 

The last one of WAN Interface List displays your PC’s current address. 

 

Figure 4-20 

30