Avaya 3.7 Manual De Usuario

To set the amount of time delay to switch from a secondary interface to the primary interface 
once the primary link has been detected, configure the Hold Down Timer. This delay provides 
the necessary time for the primary interface to stabilize. The Hold Down Timer applies to 
failover conditions occurring due to a link-level failure on the public primary interface only.

The Hold Down Time value is expressed in seconds. The value range is 0 to 3600 seconds. The 
default value is 60 seconds.

Note:

There is a scenario in which the switchover from the public backup interface to 
the public interface will occur before the hold down timer has expired. If the idle 
timer is set to a value less than that of the hold down timer, and the public primary 
interface link becomes available while at roughly the same time traffic ceases to 
flow through the public backup interface, the switchover will occur when the idle 
time expires rather than when the hold down timer expires.

Private. - The private network interface usually provides connection to your private local area 
network (LAN) or your corporate LAN. The private network interface can be configured with 
Static, DHCP Server or DHCP Relay.

Semi-private. - The semi-private network interface provides connection to a network whose 
equipment can be made physically secure, but whose medium is vulnerable to attack, such as a 
wireless network used within a corporation’s private network infrastructure). Traffic on the 
semi-private interface is usually encrypted. Only one semi-private zone can be configured on 
the security gateway. 

DMZ. - The demilitarized zone (DMZ) network interface is usually used to provide Internet 
users with access to some corporate services without compromising the private network where 
sensitive information is stored. A DMZ network contains resources such as Web servers, FTP 
servers, and SMTP (e-mail) servers. Because DMZ networks are vulnerable to attack (that is 
denial of service), corporations usually add additional security devices such as intrusion 
detection systems, virus scanners, and so on. Only one DMZ zone can be configured on the 
device.

Management. - The management interface connection can be configured to simplify network 
deployments, to eliminate enterprise network dependencies on switches or routers. The 
management network interface is usually used as an access point for a dedicated VPNmanager 
management station or as a dedicated interface for dumping log messages to a syslog server.