Cabletron Systems BRIM-E100 Manual De Usuario

Chapter 5: Local Management

2. Use the LEFT-ARROW key to move back to the Advertised Ability 

selection and use the SPACE bar to select the next mode you wish to 
enable or disable. Use the RIGHT-ARROW key to move across to the 
Enable/Disable field to the right of the selection. Use the SPACE bar 
to select Enable or Disable. Press ENTER. Continue this process until 
you have completed enabling or disabling the advertised modes.

3. Use the ARROW keys to highlight the SAVE command. Press 

ENTER. The message “Save Done!” appears and Local Management 
saves the changes to memory.

This section provides instructions for manually configuring the 
BRIM-E100 with an FE-100FX Fast Ethernet Interface Module installed. 
The BRIM-E100 Setup screen (see Figure 5-1) must be accessed through 
Local Management before proceeding with the following steps.

Use this field to set the active technology. This field toggles between 
100Base-FX and 100Base-FXFD (full duplex). Use the following steps to 
set the active technology:

1. Use the ARROW keys to highlight Desired Operational Mode and 

use the SPACE bar to select 100Base-FX or 100Base-FXFD (full 
duplex). Press ENTER. The BRIM-E100 now operates in the chosen 
mode.

2. Use the ARROW keys to highlight the SAVE command. Press 

ENTER. The message “Save Done!” appears and Local Management 
saves the changes to memory.

book  Page 6  Friday, April 19, 1996  9:53 AM