Bay Technical Associates none Manual De Usuario

Starting the ARN

114200 Rev. A

2-15

 

You can use either the ARN monitor or the Technician Interface to configure the 
ARN to local boot. However, you must use the Technician Interface to run the 
Quick-Start script.

Before starting the local boot procedure, ask your network administrator to assist 
you in completing the Quick-Start worksheets in Appendix B.

To use the local boot feature:

At the command line prompt, type the following command and press the 
Return key to configure the ARN to use its local config file:

Continuing with the local boot option requires that you have already 

logged in to the Technician Interface or ARN monitor command line software. 
Refer to the previous section, “Logging in to the Command Line Software,” 
for instructions.

The default setting for finding the software image is 

local

; you do not 

have to change this setting for the local boot option.

If the ARN tries to local boot and cannot find a software image or 

configuration file, it attempts to netboot once. If both attempts fail, the ARN 
continues to local boot and netboot until it boots successfully. If the ARN 
remains in this loop, refer to “Interrupting the Boot Process” earlier in this 
chapter.